Sale!

24 volt, 140 amp, Single Phase, 240v Battery Charger (Suitable for 600ah – 870ah batteries)

£385.34 + VAT

1ph (240 vac) 24 volt 140 amp Battery Charger (suitable for 600Ah – 1000Ah batteries)

Now replaced by our HFHX24100 high frequency battery charger

By choosing this High Frequency type battery charger you will be benefiting from the following advantages when compared to a Standard battery charger

Far lower current demand from your mains power supply – Reducing the need for large power sockets, large power supply breaker switches and heavy wiring
Small compact and lightweight
Highly efficient “Constant Current” charge curve

Model HFHX24100

Categories: 24v Forklift Battery Chargers, Forklift Battery Chargers, Forklift Battery Chargers2, T.C.E Tag: single-phase

Description

Suitable for use with all brands and makes of WET/Flooded Forklift Batteries

High Frequency Output – 24 volts 100 amps (100 amps DC High Frequency is approximately equivalent to a 160 amps DC conventional charger)

Input – 1ph (240vac) 16a minimum

Suitable for use with batteries of a capacity 600Ah – 1000Ah batteries (8hr-15hrs)

* Battery capacity range is given as a guide and is based on a battery in good condition. This charger will fully charge batteries of a larger capacity if put on charge before being fully discharged.

WALL MOUNTED OR ON-BOARD

The HFHX Series is ideal to be installed either on your wall as normal or onboard electrical vehicles thanks to its reduced dimensions.

PROTECTION DEGREE

All the HFHX Series are IP65 rated

This degree of protection allows the charger to be totally protected against dust, sand and in general any solid physical body of small dimensions, able to withstand low-pressure water jets from all directions. Please note that this product should not be mounted directly in the open air, unprotected from the elements

Ideal to also be used in outside environments under a protective shelter.

BUMP RESISTANT

The casing, which acts as a heat sink, it’s resistant to bumps.

The cooling fan is protected by the dedicated grid that deters it from being damaged over time.

Features

Connections
– Single Phase 230Vac +-10% / 50-60Hz
IP65 protection
Power Factor: ≥ 0,99
Efficiency: ≥ 94%
Noise: ≤45 dB
Long lasting cooling fan
PCB completely covered by special resin
Ideal for many different industrial environments (high or low temperatures, lot of humidity, altitude,…)
Possibility to install additional accessories
High frequency resonant technology