Additional information
| Weight | 64 kg |
|---|---|
| Dimensions | 39 × 51 × 89 cm |
| terminal-options | AP – Automotive Post, LTP – Low Profile Terminal |
48 volt, 100 amp, Single Phase, 240v Battery Charger (Suitable for 430ah – 620ah batteries)
£580.00 + VAT
NOW REPLACED by PBQE 1ph 240vac 48v 60a High Frequency Battery Charger (Suitable for 370ah – 750ah Batteries)
By choosing this High Frequency type battery charger you will be benefiting from the following advantages when compared to a Standard battery charger
- Far lower current demand from your mains power supply – Reducing the need for large power sockets, large power supply breaker switches and heavy wiring
- Small compact and lightweight
- Highly efficient “Constant Current” charge curve
Description
Model No. PBQEX4860
Suitable for use with all brands and makes of WET/Flooded Forklift Batteries
High Frequency Output – 48 volts 60 amps (60 amps DC High Frequency is approximately equivalent to a 100 amps DC conventional charger)
Input – 1ph (240vac) 16a minimum
Suitable for use with batteries of a capacity of 400Ah – 640Ah* (8hr-15hrs)
* Battery capacity range is given as a guide and is based on a battery in good condition. This charger will fully charge batteries of a larger capacity if put on charge before being fully discharged.
WALL MOUNTED OR ON-BOARD
The PBQE Series is ideal to be installed either on your wall as normal or onboard electrical vehicles thanks to its reduced dimensions.
PROTECTION DEGREE
The PBQE Series isIP65 rated
This degree of protection allows the charger to be totally protected against dust, sand and in general any solid physical body of small dimensions, able to withstand low-pressure water jets from all directions. Please note that this product should not be mounted directly in the open air, unprotected from the elements
Ideal to also be used in outside environments under a protective shelter.
BUMP RESISTANT
The casing, which acts as a heat sink, it’s resistant to bumps.
The cooling fan is protected by the dedicated grid that deters it from being damaged over time.
Features
- Connections
- – Single Phase 230Vac +-10% / 50-60Hz
- IP65 protection
- Power Factor: ≥ 0,99
- Efficiency: ≥ 94%
- Noise: ≤45 dB
- Long lasting cooling fan
- PCB completely covered by special resin
- Ideal for many different industrial environments (high or low temperatures, lot of humidity, altitude,…)
- Possibility to install additional accessories
- High frequency resonant technology
Safety
- Protection against overheating
- Protection against reverse polarity
- Protection against short circuit
- Self-diagnostic in case of anomaly
- Automatic interruption of the charging cycle when charge is completed
- Active PFC
- Soft-start when charge begins
DIMENSIONS
305mm x 217mm x 126mm (+/-2mm)
View Drawing 48V60A DRAWING
Related products
-
T.C.E 80 volt / 100 amp – Single Phase 240v (suitable for batteries 430ah – 620ah)
£590.00 + VAT Add to basket -
24 volt, 140 amp, Three Phase, 240v Battery Charger (Suitable for 600ah- 870ah batteries)
£388.00 + VAT Add to basket -
48 volt, 50 amp, Single Phase Battery Charger
£355.34 + VAT Add to basket -
T.C.E 72 volt / 120 amp T.C.E Three Phase (suitable for batteries 500ah – 750ah)
£558.00 + VAT Read more
