HFHX 1ph 240vac 24v 30a High Frequency Battery Charger (suitable for 280ah – 450ah batteries)

£237.00 + VAT

Description

Suitable for use with all brands and makes of WET/Flooded Forklift Batteries

High Frequency Output – 24 volts 30 amps (30 amps DC High Frequency is approximately equivalent to a 50 amps DC conventional charger)
Input – 1ph (240vac) 13a minimum
Suitable for use with batteries of a capacity of 180Ah – 300Ah* (8hr-15hrs)

* Battery capacity range is given as a guide and is based on a battery in good condition. This charger will fully charge batteries of a larger capacity if put on charge before being fully discharged.

WALL MOUNTED OR ON-BOARD

The HFHX Series is ideal to be installed either on your wall as normal or onboard electrical vehicles thanks to its reduced dimensions.

PROTECTION DEGREE

All the HFHX Series is IP65.

This degree of protection allows the charger to be totally protected against dust, sand and in general any solid physical body of small dimensions.

Ideal to also be used in outside environments under a protective shelter.

BUMP RESISTANT

The  box, that acts as a heat sink, it’s resistant to bumps.

The cooling fan is protected by the dedicated grid that avoids it from being damaged over time.

Features

• Connections
• –  Single Phase 230 Vac +-10% / 50-60Hz
• IP65 protection
• Power Factor: ≥ 0,99
• Efficiency: ≥ 94%
• Noise: ≤45 dB
• Long lasting cooling  fan
• PCB completely covered by special resin
• Ideal for many different industrial environments (high or low temperatures, lot of humidity, altitude,…)
• Possibility to install additional accessories
• High frequency resonant technology

Safety

• Protection against overheating
• Protection against reverse polarity
• Protection against short circuit
• Self-diagnostic in case of anomaly
• Automatic interruption of the charging cycle when charge is completed
• Active PFC
• Soft-start when charge begins

Dimensions

200.7mm x 124.8mm x 115.4mm (+/-0.5mm)