PBQE 1ph 240vac 48v 60a High Frequency Battery Charger (Suitable for 370ah – 750ah Batteries)

£580.00 + VAT

Description

Suitable for use with all brands and makes of WET/Flooded Forklift Batteries

High Frequency Output – 48 volts 60 amps (60 amps DC High Frequency is approximately equivalent to a 110 amps DC conventional charger)

Input – 1ph (240vac) 16a minimum

Suitable for use with batteries of a capacity 370Ah – 750Ah batteries (8hr-15hrs)

* Battery capacity range is given as a guide and is based on a battery in good condition. This charger will fully charge batteries of a larger capacity if put on charge before being fully discharged

STATIONARY

The PBQE Series is ideal to be used as a wall mounted stationary charger 

PROTECTION DEGREE

All the PBQE4860 Series is IP65.

This degree of protection allows the charger to be totally protected against dust, sand and in general any solid physical body of small dimensions.

Ideal to also be used in outside environments under a protective shelter.

BUMP RESISTANT

The box, that acts as a heat sink, it’s resistant to bumps.

The cooling fan is protected by the dedicated grid that avoids it from being damaged over time.

Features

• Connections
• –  Single Phase 230Vac +-10% / 50-60Hz
• IP65 protection
• Power Factor: ≥ 0,99
• Efficiency: ≥ 94%
• Noise: ≤45 dB
• Long lasting cooling  fan
• PCB completely covered by special resin
• Ideal for many different industrial environments (high or low temperatures, lot of humidity, altitude,…)
• Possibility to install additional accessories
• High frequency resonant technology

Safety

• Protection against overheating
• Protection against reverse polarity
• Protection against short circuit
• Self-diagnostic in case of anomaly
• Automatic interruption of the charging cycle when charge is completed
• Active PFC
• Soft-start when charge begins

DIMENSIONS

305mm x 217mm x 126mm (+/-2mm)

View Drawing 48V60A DRAWING